Patricio Vela: Course Wiki

This module explores trajectory generation using the Jacobian. The objective here is to create a trajectory for the arm to follow, at only the position level. As the piktul manipulator space has equal dimension to the $R^3$ output position space, tracking a Euclidean position is feasible. It is possible to specify the 3D position as a function of time and get it to follow the trajectory, presuming that the trajectory is within the reachable workspace (for position).

Create a resolved rate trajectory generation member function that will do so for the piktul. Call the function genPositionTrajectory where it is assumed that some kind of position function of time and linear velocity function of time is given in a structure built with traj.position, traj.velocity, and traj.tspan fields. The output of the function should be a set of joint angles versus time that will move the arm to follow the specified trajectories. It can be in the output format of ode45 and should be in a structure with the fields as per: jtraj.alpha and jtraj.time.

Furthermore, write a function called followJointTrajectory that takes in a structure whose fields are alpha and time much like the output of genPositionTrajectory. The function will then command the arm to follow the specified trajectory. Doing this should be like a combination of the arm display as a movie code plus the joint angle command code for the piktul from earlier homeworks. You should also write a piktul member function called posJacobian that computes the linear velocity of the end effector (in world coordinates, not body coordinates) as a function of the \alpha coordinates. For completeness, you should include all $\alpha$ coordinates in it (the last two will just have zero columns since they don't contribute to linear movement).

To make the narrative clearer, the following functions should be written:

  function alphaTraj = genPositionTrajectory(ptraj, tspan, alpha0)
  end
  
  function followJointTrajectory(jtraj, tspan, nsteps)
  end
  
  function mJ = posJacobian(alpha)
  end

Since the genPositionTrajectory function will have to numerically integrate using ode45' or a similar function, a resolved rate differential equation function will be needed to: <code> function alphaDot = posODE(t, alpha) end </code> This can be a hidden function within the 'genPositionTrajectory member function or it can be a protected member function (the easiest would be to make it a public member function). It is the main part that has the resolved rate equations. Code stubs to insert into the piktul class can be found resolvedstubs.m.

For this version, you will have to actually use the optional time argument to setArm which is the time duration of the movement. Whatever time step you use in the for loop to move the arm, you will have to send a time duration that is 10\% longer, then pause for the actual duration before resuming the next loop iteration. The reason being that the little controller board actually implements spline smoothing to go from one joint angle to another, so if you specify the actual time, it will do the whole start and stop thing. If you specify a time that is a little bit longer, then it won't have yet stopped before moving the the next command. You must send an argument, otherwise it will use the default argument of 4 seconds, which you will not like and will not look good.

Be careful about the whole radians versus degrees thing. The piktul inputs are in degrees, so you'll probably need to use Matlab's cosd and sind functions, which take the angular arguments in degrees. Also, the angular velocities will have to be scaled by $180/\pi$ to convert them to degrees since the pseudo-inverse of the Jacobian will give results that are sensible in radians per second (not degrees per second). Within the position Jacobian function, the conversion to degrees for the output should already be done.

Back – Main