Differences

This shows you the differences between two versions of the page.

--- embedded:adventures:dualpower [2016/09/25 13:33] – pvela
+++ embedded:adventures:dualpower [2024/08/20 21:38] (current) – external edit 127.0.0.1
@@ Line 26: / Line 26: @@
 We found [[http://www.farnell.com/datasheets/1866419.pdf|this MCT6 datasheet]] to be helpful. The MCT6 chip contains 2 optoisolators. Here is how to connect the first one:
   - Connect your output wire from the mBed to pin 1.
-  -  Connect pin 2 to mBed ground with a small valued (1k) resistor.
+  - Connect pin 2 to mBed ground with a small valued (1k) resistor.
   - Connect pin 7 to external DC ground with a large resistor (10k).
   - Connect pin 8 to external DC Vcc and to the input signal wire of whatever you need to control.
+In this described configuration, the right hand side appears to be operating in pull-up mode.
 ;#;
 {{:embedded:adventures:optoisolator_mBed_RCservo.jpg?500|}}
@@ Line 37: / Line 37: @@
 ;#;
+The image is a bit messy due to the wires being everywhere, but it should be somewhat clear that the second, smaller proto-board has an opto-isolator on it.  It is acting as the bridge between the mBed side and the RC servomotor side. The blue wire at pin 8 of the MCT6 ultimately connects to the second (signal) pin of the servomotor.  The first and third (right-most) wires and pins are the power and ground. It looks to be that the third pin is ground.
 ---------------
 ;#;
 [[ Basics:Adventures | Main]]
 ;#;