Differences

This shows you the differences between two versions of the page.

--- ece4560:controlbox:connecting [2018/10/20 13:19] – [Interfacing the Arduino Control Box] pvela
+++ ece4560:controlbox:connecting [2024/08/20 21:38] (current) – external edit 127.0.0.1
@@ Line 6: / Line 6: @@
 ==== Windows ====
+-----------------
+To determine the COM port label in Windows, open the "Devices and Printers" dialog box.  If the control box is plugged in and the drivers for it are installed, it should pop up as some kind of Arduino device.  Click on it to open up another dilog box.  Click on the //Hardware// tab and you will be a listing of properties.  The port name is one of those properties.  It may be COM3 or COM7 or some other number.
-To determine the COM port label in Windows, open the "Devices and Printers" dialog box.  If the control box is plugged in and the drivers for it are installed, it should pop up as some kind of Arduino device.  Click on it to open up another dilog box.  Click on the //Hardware// tab and you will be a listing of properties.  The port name is on of those properties.  It may be COM3 or COM7 or some other number.
+==== MacOS / Linux ====
+-----------------------
+The way I figure this out is to first type in:
+<code>
+ls /dev/tty*
+</code>
+and then plug in the device.  After waiting a little, I then retype the commant
+<code>
+ls /dev/tty*
+</code>
+and see what is different.  The different line is the name of the device.  I figure you know how to adjust things to get that name to work for your computer.
+=== Drivers ===
+If you are not sure that the drivers are being loaded, then it helps to type ''dmesg'' before plugging it in and note that last few lines (or type ''dmesg | tail -50''). Plug in the device and wait a little bit (say 10 seconds), then enter the ''dmesg'' command again.  There should be new output for when the device was plugged in.  Importantly, there should be some message indicating that a driver (module) was found and loaded.  If not, then you may need to download and install the appropriate drivers.
+=== Access to Device ===
+You might not be able to output to the device through the virtual COM port.  This could be a function of two things, one being permissions and the other being the virtual serial port settings.
+**Permissions.** Usually in linux, the best way is to add oneself to the group list with read/write permissions for the serial ports.  This might be the ''dialup'' group.  The best is to check what group has access to the device file for the control box, then to add yourself to that group.
+**Port Settings.** Another issue can be the serial communications parameters.  They might default to some transmission rate or settings that don't agree with what the control box device actually wants.  You will have to modify the settings to align with what is expected.
 ---------